Camden Plumbing 2017: When Do You Need to Replace Your Water Heater

Reguar maintenance is an important aspect of extending the life of your water heater, and problems, like leaking or not heating up, can be managed by repair or replacement. Allow us to share some troubleshooting tips to have a long-lasting water heater because as simple as replacing a heating element or pressure-relief valve can help resolve water heater problems. You can always contact a professional such Camdem Plumbing Consultant to help you with any of your water heater problems, though simple water heater repairs that can be done DIY. The average life expectancy of a water heater is eight to twelve years.

You need a replacement if your water heater is more than ten years old, works erratically, with leaks around the base of the tank, or stop working. The most common problem connected with a water heater is that the water is not as hot as you expected or you want it to be, which is usually caused by a defective heating element, or a faulty thermostat. When maintaining your electric water heater, it is important to ensure that the power is connected, reset the thermostat, flush the heater to eliminate sediments from the tank, thermostat, and heating element replacement, and raising thermostat temperature. When managing a gas water heater, you need to remove sediment by flushing, replace the Thermo coupler and clean the burner, ensure that the pilot is lit and the gas is connected, insulate hot water pipes, and raise the temperature setting on the thermostat. Buildup of sediments in the tank may cause sizzling or hissing noises, so it is important to drain the tank until the water clears. To resolve build up problems, remove and soak heating element in a pan filled with white vinegar up to an hour and any collected scale should be scraped off. To resolve leaking pressure-relief valve, it must be replaced. For leaking water supply pipes, you have to tighten the fittings or replace if tightening it doesn’t resolve the issue.

It is essential to drain your water heater at least twice a year to remove sediments that cause corrosion and to increase efficiency. One way to test the pressure-relief valve is lifting the handle of the valve and allowing it t snap back, that should release a burst of water, otherwise, a new valve should be installed. If you will choose to replace your water heater, the important features you need to check are the gallon capacity, recovery rate, dimensions, and energy efficiency ratings. Allow Camden Plumbing Consultant to help you with your water heater replacement needs, please visit their website or homepage, or contact them directly.5 Uses For Plumbing

3 Repairs Tips from Someone With Experience

Uncategorized